If you initialized a disk that held files, stop before creating partitions or formatting it. Initialization changes disk-management information; it is not the same event as formatting a volume or overwriting an entire disk. Recoverability depends on the structures and file content still readable, plus any actions taken afterward.
Reconstruct the sequence
Write down whether you selected MBR or GPT, whether a new simple volume was created, and whether formatting or copying followed. Distinguish a prompt you canceled from initialization you confirmed. Include the original disk size and the partition arrangement if you have a trustworthy record.
Microsoft’s initialization instructions concern preparing new disks and warn against applying the process to existing data. Do not repeat those preparation steps to try to undo the mistake.
The difference matters operationally. Initialization affects disk layout information. Creating a partition defines a region that a file system may use. Formatting builds new file-system structures there. Subsequent file copies write content. Several of these can happen in one wizard session, so “I only initialized it” should be checked against the actual sequence.
Identify the physical source
On a separate Windows environment, record the affected drive’s model, capacity and connection. Use Disk Management to observe its state, then cancel any further preparation prompts. Do not guess the original starting sector and write a replacement table simply because an online example uses the same drive size.
If the disk cannot report a credible capacity or reads inconsistently, resolve that issue before scanning. For a stable source, preserve a whole-disk image if appropriate. A whole-disk image keeps the currently readable layout and data together; an image of a newly created empty volume could omit the old data region you need.
XRecovery can create IMG images and scan supported raw images. Store the image and all recovered output on healthy separate storage, and avoid modifying the only preserved image while evaluating later repair options.
Find files without rebuilding the original layout
XRecovery supports finding files from lost partitions. Select the affected physical disk or preserved image and inspect candidate results. Look for recognizable folder contents, expected size ranges and dates rather than relying on a single partition label.
If multiple results represent different historical layouts, export a small, distinct set from each promising candidate to separately labeled destination folders. Open the files to determine which result contains the needed versions. A directory listing can look convincing while the underlying file bytes are incomplete.
After validating representative output, export the highest-value folders and then check completeness against your own file inventory or backups. Keep damaged exports separate from intact files, and record which ones still need attention.
When the result is incomplete
A previous partition map does not guarantee preservation of every file, and an initialized disk is not automatically empty of recoverable content. Avoid both assumptions. If later formatting or installations occurred, expect those writes to affect specific regions rather than applying a universal outcome.
Partition-table restoration is a different task from exporting files. Consider it only after protecting the data and confirming an internally consistent layout. Preserve the actual disk layout and encryption information before considering any in-place change; a procedure for another layout may alter the wrong metadata. If the layout is uncertain or the unique data is important, ask for an assessment with the event sequence and preserved image available.