Pause or Continue an XRecovery Scan and Handle an Interruption

Pause a live scan deliberately and distinguish continuation from stopped, closed, or disconnected work.
XAppSet Team
Published on November 14, 2026

Use pause and continue for a temporary break in the current XRecovery scan. Treat stopping, closing the application, losing power, and disconnecting the source as different events. Before leaving a long task, preserve available scan information and verified exports without assuming that every interrupted operation can resume from the same point.

External drive, USB flash drive and an M.2 SSD beside a laptop

Pause a current scan deliberately

Use the scan’s pause control and allow the application to reach its paused state. Keep the source connected and the computer available. Pausing a scan is not a reason to remove the disk or change its contents in another application.

When ready, use the current scan’s continue control. Confirm that you are continuing the same source and session rather than starting a separate scan with different settings. XRecovery supports pausing and continuing the current scan; this is distinct from recovering work after the process has closed.

If the source is unstable or showing abnormal hardware symptoms, pausing is only a temporary operational step. Assess whether further reading is appropriate before continuing.

Distinguish pause from stop or exit

Stopping a scan can leave a partial set of findings. A partial list may still contain useful candidates, but it should not be described as the result of examining every intended part of the source.

Closing the application can remove the current in-memory working state. Before a planned exit, use supported scan-result saving where available and retain the corresponding disk or image. A saved result is search information, not a backup of all candidate file contents.

Do not assume that an export already in progress is complete merely because the scan has been paused. Scanning and writing selected files are separate operations; check the relevant status and output before changing the session.

Plan for sleep, updates, and power

For a long task, use a reliable power connection. In Windows Settings, search for sleep settings and review when the computer may sleep or restart. Coordinate with a managed device’s administrator when policy controls those settings. Do not make unrelated system changes to the affected source just to keep a recovery task running.

Keep the output device securely connected too. Losing the destination during export can produce incomplete output even when the original scan remains available.

If you must stop for another reason, record the source identity, application version, current stage, approximate progress, and whether results were saved. These notes help distinguish what was preserved from what remains uncertain.

After a crash or unexpected disconnection

First check the source’s condition and identity. An unexpected disconnect can be a cable or power problem, but repeated failures can indicate a device that should not undergo more ordinary scans.

Preserve any saved results and already exported files. Reconnect only through an appropriate stable access path. If loading saved results is possible, verify the correct source and inspect a known candidate before continuing file recovery.

If the current operation cannot be continued, a new scan may be necessary when the source remains readable and another attempt is appropriate. Do not label it a continuation of a complete earlier scan or assume it will produce identical results.

Check partial exports before retrying

Keep a separate folder for files written before the interruption. Inspect their sizes and actual content, especially the file that may have been writing when the interruption occurred. A destination filename alone does not establish a complete export.

Save a later retry into a distinguishable destination so you can compare results without overwriting a usable file. For important content, open the relevant document sections or complete recording after export.

Before continuing the recovery

Record whether the work is a paused live scan, a stopped partial scan, a saved result awaiting its source, or a verified exported set. These are useful operating states with different next steps.

If you need help, provide the event, error, versions, source/destination identities, and what remained available afterward. That is more informative than saying only that “resume did not work,” and avoids unnecessary repeated reads while the actual interruption is investigated.

XRecovery support guides

Privacy Overview
XAppSet

This website uses cookies so that we can provide you with the best user experience possible. Cookie information is stored in your browser and performs functions such as recognising you when you return to our website and helping our team to understand which sections of the website you find most interesting and useful.

Strictly Necessary Cookies

Strictly Necessary Cookie should be enabled at all times so that we can save your preferences for cookie settings.